Duplo DPB-500, Instruction Manual, Page: 31 / 148

1-17
CHAPTER 1 BEFORE OPERATION
7. Precautions on Hot Melt Glue
a. Precautions
Before you use the hot melt glue, read "Hot Melt Glue" in "Safety Precautions" ( p.iv). Also, read
carefully the handling precautions supplied with hot melt glue you are going to use.
1) When you handle the hot melt glue, make sure that you wear protection gloves, long-sleeved
clothes, eye protectors to prevent burn injuries.
2) In case the hot melt glue gets into your eye, cool it with cold water immediately and get prompt
medical attention.
3) The glue attached to your skin may cause a burn injury. Cool the affected area with cold water
immediately and get prompt medical attention.
4) Fumes, which comes out of the machine while the glue is being melted, may irritate your eyes,
nose and throat. If you do not feel well, go out into the fresh air.
5) Because the hot melt glue is combustible, do not put the glue close to fire.
b. Recommended Hot Melt Glue
Destination: 208 V, 240V 60 Hz (USA)
Manufacturer: US ADHESIVE COMPANY
Model: HM-53-R
Destination: 380 to 415 V 50/60 Hz (Europe)
Manufacturer: NATIONAL STARCH&CHEMICAL
Model: COOL BIND 1450
c. Ventilation
This machine will exhaust fumes to the outside of the machine using the fan while the hot melt glue
is being melted at high temperatures. The fumes may irritate your eyes, nose and throat.
Make sure that you let the fumes exhausted from the machine go outside or to a well-ventilated
place. If you feel sick, go out into the fresh air.