29
Service Manual for Proofer Oven with Touch Screen Controls (TSC)
Gasket
is slightly
compressed
Figure 37: Door Handle Adjustment
2. Adjust the handle to its proper position.
3. Tighten the screws.
OVEN AIR WASH DOOR ADJUSTMENT
WARNING
THE OVEN MAY BE HOT! ALLOW THE
UNIT TO COOL BEFORE BEGINNING ANY
DOOR ADJUSTMENT PROCEDURES.
Air Wash Door Adjustment – Hinge Side
To adjust the Hinge Side of the door, use this procedure.
1. If open, close and latch the door.
2. Remove the Hinge Covers.
3. Loosen the screws on the hinges.
Gasket
is slightly
compressed
Figure 38: Proper Hinge Side Adjustment
4. Adjust the door position by moving the doorframe
to seal any gap between the gasket and the oven
front near the hinges. Tighten the hinge screws.
5. Perform the DOOR GASKET COMPRESSION
CHECK.
6. If needed, repeat the above procedure or go to step
7. Otherwise, replace the Hinge Covers.
7. Perform the Air Wash Door Adjustment – Handle
Side procedure, below. (Do not replace the hinge
covers yet.)
CAUTION: Be careful not to over-compress the
gasket or it will cause the door to bind
near the hinges.
Air Wash Door Adjustment – Handle Side
To adjust the Handle Side of the door, use this procedure.
1. If open, close and latch the door. Ensure that the
inner and outer doors are latched together.
2. Loosen the screws along the outer edge of the Door
Handle.
3. Adjust the door position by moving the doorframe
to seal any gap between the gasket and the oven
front near the handle.
4. Tighten the screws.
Gasket
is slightly
compressed
Figure 39: Proper Door Handle
Side Adjustment
