Service Manual for Proofer Oven with Touch Screen Controls (TSC)
8
Figure 1: Proofer – Rear Panel Removed
1. Place the unit’s Power Switch in its OFF position,
and follow the proper Lockout/Tagout procedures.
2. Remove all of the self-tapping sheet metal screws
that secure the Rear Panel to the Proofer. Set aside
for reuse.
3. Remove the Rear Panel to gain access to the
components located at the rear of the Proofer.
Oven Rear Panels
WARNING
BEFORE PERFORMING ANY SERVICE THAT
INVOLVES ELECTRICAL CONNECTION
OR DISCONNECTION AND/OR EXPOSURE
TO ELECTRICAL COMPONENTS, ALWAYS
FOLLOW THE ELECTRICAL LOCKOUT/
TAGOUT PROCEDURE. DISCONNECT ALL
CIRCUITS. FAILURE TO COMPLY CAN
CAUSE PROPERTY DAMAGE, INJURY OR
DEATH.
The oven section of the unit has three rear panels. The
Center Panel provides access to the Oven Light Fixtures
and Oven Light Fixture wiring harness. Right and Left
Panels provide access to the Oven Burner Element
connections and Element wiring harnesses.
Figure 2: Oven – Right Side Panel Removed
1. Place the unit’s Power Switch in its OFF position,
and follow the proper Lockout/Tagout procedures.
2. Remove the screws securing the Center Panel.
Retain for reuse.
3. Remove the Center Panel to gain access to Light
Fixtures and wiring harness.
Note: The Center Panel side screws must be removed
when removing either of the side panels.
4. Remove the screws securing the Side Panels. Retain
for reuse.
5. Carefully remove the insulation to access to the
Oven Burner Element connections and Oven Burner
Element wiring harness. Retain the insulation for
reuse.
