Service Manual for Proofer Oven with Touch Screen Controls (TSC)
28
ADJUSTMENTS
DOOR GASKET COMPRESSION CHECK
The Door Gasket Compression Check may be performed
on all styles of Proofer Oven doors.
WARNING
THE OVEN OR PROOFER MAY BE HOT!
ALLOW THE UNIT TO COOL BEFORE
BEGINNING ANY DOOR ADJUSTMENT
PROCEDURES.
BAKING CENTER
Figure 35: Door Gasket Compression Check
Perform the following procedure to determine if door
adjustments are necessary:
1. Close the door with a dollar bill between the gasket
and the front of the oven. There should be resistance
when the dollar bill is pulled free of the door.
2. Perform this check in several places and readjust
the door if necessary using one or both of the
procedures below.
PROOFER DOOR GASKET ADJUSTMENT
WARNING
THE OVEN OR PROOFER MAY BE HOT!
ALLOW THE UNIT TO COOL BEFORE
BEGINNING ANY DOOR ADJUSTMENT
PROCEDURES.
To adjust the door on the hinge side, use this procedure:
1. With the door closed, remove the hinge covers and
loosen (don’t remove) the six screws that hold the
hinges to the door.
Gasket
is slightly
compressed
Figure 36: Door Hinge Adjustment
2. With the screws loosened, the door can be move in
and out on its frame. Move the door to the desired
position.
Note: When adjusting the doors in and out position,
don’t over compress the gasket. This will cause the
door to bind on the hinge side.
3. Once the door is positioned properly, tighten the
screws and replace the hinge covers.
The door can also be adjusted on the handle side:
1. Loosen, but do not remove, the two screws that
hold the handle in place.
