Service Manual for Proofer Oven with Touch Screen Controls (TSC)
10
Oven Ceiling Panel
WARNING
BEFORE PERFORMING ANY SERVICE THAT
INVOLVES ELECTRICAL CONNECTION
OR DISCONNECTION AND/OR EXPOSURE
TO ELECTRICAL COMPONENTS, ALWAYS
FOLLOW THE ELECTRICAL LOCKOUT/
TAGOUT PROCEDURE. DISCONNECT ALL
CIRCUITS. FAILURE TO COMPLY CAN
CAUSE PROPERTY DAMAGE, INJURY OR
DEATH.
Figure 5: View of Oven Components
with Ceiling Panel Removed
1. Place the unit’s Power Switch in its OFF position,
and follow the proper Lockout/Tagout procedures.
2. Remove the Oven Racks
3. Remove the screws securing the panel. Retain
screws for reuse.
4. It may be necessary to pry the panel forward from
the front of the unit. Be careful not to damage the
fan blade when removing the panel.
Access to Oven Heating Elements, Fan Blade, Oven
RTD and Hi Limit Thermostat, is available with the
Oven Ceiling Panel removed.
Electrical Compartment Access Panel
WARNING
BEFORE PERFORMING ANY SERVICE THAT
INVOLVES ELECTRICAL CONNECTION
OR DISCONNECTION AND/OR EXPOSURE
TO ELECTRICAL COMPONENTS, ALWAYS
FOLLOW THE ELECTRICAL LOCKOUT/
TAGOUT PROCEDURE. DISCONNECT ALL
CIRCUITS. FAILURE TO COMPLY CAN
CAUSE PROPERTY DAMAGE, INJURY OR
DEATH.
It is not necessary to move the unit to gain access
to the Electrical Component Compartment. It might
become necessary to remove the unit from the wall
if troubleshooting leads into other areas. Refer to
the specific component section of this manual when
replacing a component in the Electrical Compartment.
Remove
Loosen
Figure 6: Electrical Compartment
Access Panel Screw Locations
1. Place the unit’s Power ON/OFF Switch in its OFF
position and follow the proper Lockout/Tagout
procedures.
2. Refer to the drawing and loosen the appropriate
screws.
3. Also, referring to the drawing remove the two
screws at the top of the Control Access Panel.
4. Pull the panel forward then pivot it downward.
