11
Owner’s Manual for Duke Flexbake 5
TM
Proof and Bake Oven with WiFi Connectivity
UNPACKING UNIT
Inspect the shipping carton and/or container, carefully noting
any exterior damage on the delivery receipt; also note any
damage not evident on the outside of the shipping container
(concealed damage). Contact the carrier immediately and file
a damage claim with them. Save all packing materials when
filing a claim. Freight damage claims are the responsibility of
the purchaser and are not covered by the warranty.
•
Follow the instructions on the Carton Box for unpacking
the unit.
•
Inspect unit for damage such as, broken glass, etc.
•
Report any dents or breakage to source of purchase
immediately.
•
Do not attempt to use unit if damaged.
•
Remove all materials from unit interior.
•
If unit has been stored in extremely cold area, wait a few
hours before connecting power.
UNIT PLACEMENT
•
Do not install unit next to source of heat, such as deep
fryer, etc.
•
Install unit on level surface floor.
•
Minimum Clearance of 6" (152mm) must be maintained
between the unit and any combustible substance.
•
Maintain a minimum clearance of 2 inches (50 mm) on
both sides and the rear of the unit for proper operation
and cooling.
NOTE: The space above the oven should be open to
the full ceiling height and have suitable ventilation or
a hood to remove heat and humidity.
Connection of the unit to the mains supply
MUST
be
performed by an authorized person in accordance with codes,
standards, and laws governing the installation site using
properly rated all poles mains protection, all poles mains
disconnects, safety ground earthing, and shall be a minimum
of 48” (1.2 meter) long to allow the equipment to be moved.
USA and non-EU Countries must use flexible conduit within
variances that may be required by local electric codes or
regulations.
INSTALLATION
WARNING
ELECTRICAL SHOCK HAZARD UNIT
MUST BE SAFETY GROUNDED,
EARTHED.
DO NOT MODIFY, DEFEAT ELECTRICAL
CONNECTIONS OR ALTER PLUG.
ELECTRICAL CONNECTIONS
BEFORE CONNECTING THE
UNIT TO THE POWER SOURCE, VERIFY
THAT THE VOLTAGE AND PHASE OF
THE POWER SOURCE ARE IDENTICAL
TO THE VOLTAGE AND PHASE
INFORMATION ON THE DATA LABEL.
ELECTRICAL AND
GROUNDING CONNECTIONS MUST
COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL
ELECTRICAL CODE AND/OR OTHER
LOCAL ELECTRICAL CODES.
DO NOT STORE OR USE
GASOLINE OR OTHER FLAMMABLE
VAPORS OR LIQUIDS IN THE VICINITY
OF THIS OR ANY OTHER APPLIANCE.
THE CONTROL POWER
SWITCH ON THE APPLIANCE IS FOR
STANDBY POWER ONLY. FOR ALL-
POLE DISCONNECT REMOVE PLUG
FROM WALL OUTLET OR DISCONNECT
EXTERNAL ALL POLES MAINS SUPPLY.
