4
Owner's Manual for Duke Flexbake 5
TM
Proof and Bake Oven with WiFi Connectivity
• Install the Restraining Device Kit to prevent damage to mains supply connections.
• Water supply connections to the unit must comply with local plumbing code and/or
standards.
• If the equipment is moved, make sure that all utility connections are properly
disconnected. If the equipment is returned to its original position, make sure that any
retention devices and utility connections are properly connected.
• Turn the Control Power Switch off and disconnect external all poles mains supply then
allow unit to cool down before performing any service, maintenance or cleaning on the
unit.
• When working on this equipment, observe precautions in this manual or labels attached
to or shipped with this equipment and other safety precautions that may apply.
• Unit may start operation with inadvertent contact with touch screen display or from
other extraneous sources. Disconnect external all poles mains supply should abnormal
or unwanted operation occur.
• Be extremely careful when baking, loading and unloading pans, the oven interior, racks,
and pans are very hot, use appropriate precautions when handling.
• Always open the oven door very slowly. Escaping hot vapors or steam can cause minor
injury.
• Be careful of a possible slippery floor adjacent to this equipment.
• The procedures in this manual may include the use of chemical products. You must read
the Material Safety Data Sheets before using any of these products.
• Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or
any other appliance.
• Disposal of the unit must be in accordance with local environmental codes and/or any
other applicable codes.
• Always keep the equipment on top of its pallet when using a fork lift or a pallet lift truck
to move appliance.
• Always use a sufficient number of trained and qualified personnel only to move the
appliance. Do not tilt. Appliance can tip over when being moved over an uneven floor
or threshold and cause serious injury. Always apply caster brakes when not being
moved.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• If the supply cord is damaged, it must be replaced by a special cord assembly available
from Duke Manufacturing Co. or its service agent.
Note: Refer to the specifications data plate when ordering or replacing a cord set.
IMPORTANT SAFETY INSTRUCTIONS - continued
