13
Owner’s Manual for Duke Flexbake 5
TM
Proof and Bake Oven with WiFi Connectivity
INSTALLATION-continued
STEP 5
Route the loose end of the 1/2” (12.7mm) ID x 5/8”
(15.9mm) OD tube over the top horizontal brace on the back
of the stand and toward the front of the unit. From the front,
route the tube into the locating hole on the top of the drain
pail handle.
5
5
STEP 6
Inspect the tube routing and make sure there are no
kinks in the tubing.
INSTALLATION
STEP 1
This unit can be converted to other mains supply
configurations by Duke Manufacturing approved service
personnel. Call Duke Service Department for action if electrical
rating tag information is not compatible with the available
mains supply.
STEP 2
This unit is supplied with the national and
international specified water supply interconnection. Local
regulation variances or additional requirements must
be evaluated prior to installation. New water supply line
interconnection must be used when installing this unit.
Maximum / minimum supply pressure specification is 65PSI
(448kPa) / 40PSI (275kPa) for all system plumbing components.
See
INSTALLATION OF REVERSE OSMOSIS (RO) SYSTEM
section prior to water supply interconnect.
WARNING
HAZARDOUS VOLTAGE
RISK OF ELECTRIC SHOCK
DISCONNECT EXTERNAL ALL POLES
MAINS SUPPLY TO SERVICE
THIS RESTRAINING DEVICE MUST ALWAYS
BE CONNECTED WHEN THE APPLIANCE
IS IN SERVICE. DISCONNECT ONLY FOR
SERVICING AND/OR CLEANING, THEN
RECONNECT WHEN THE APPLIANCE
HAS BEEN RETURNED TO ITS NORMAL
POSITION.
STEP 3
This appliance must be secured to building structure.
A restraining device kit (#153586) provided with the unit limits
the movement of the appliance without transmitting stress to
the mains supply. Installation instructions are in the kit.
Figure: Restraining Device Kit (Part # 153586)
STEP 4
IMPORTANT: A minimum clearance of 6” (152mm)
must be maintained between the unit and any combustible
material. Maintain a minimum clearance of 2 inches (50 mm)
on both sides and the rear of the unit for proper operation and
cooling.
STEP 5
Check the swing of the door. The hinge side can be
changed by referring to the
Reversing Oven Door Swing
Direction section of this manual.
STEP 6
Check the door seal and make sure both doors close
completely. If they do not close and seal properly, refer to the
Door Gasket Adjustment section of this manual.
STEP 7
Place the wire racks in the oven.
STEP 8
Secure unit to a wall with the wall mounting brackets
provided to prevent tipping. Refer to
Installation of Wall
Mounting Brackets
section of this manual.
