Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Once all the antifreeze has been pumped out of the tubing back into the reservoir, turn
the hand pump on the antifreeze jug counterclockwise to drain the antifreeze in the reservoir
back into the antifreeze jug. If cranking the hand pump counterclockwise does not start
drawing from the reservoir, first check to make sure the coupler was attached to the reser-
voir in the correct orientation and then press and hold the LED button to start running the
pumps backwards again. While the pumps are running, turn the hand pump counterclock-
wise rapidly. The pumps will create some back-pressure in the reservoir which helps push
antifreeze to the hand pump to get it primed.
Figure 42: Turn Ignis upside down and connect the fill coupler to prepare to empty the
reservoir, pumps and tubing
4.6.5 Flush With Water
Flush With Water
:
Flushed and Emptied
With Ignis still upside down, fill the included syringe with ‘’Y’‘ fitting with water and
connect the two short tubes from the ‘’Y’‘ fitting to the needles (see Figure 43). Once again,
hold the button on the back of Ignis to run the pumps backwards. This will draw water
from the syringe through the tubing and pumps and push it into the reservoir.
Last Updated March 12, 2020
Page 54
