Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
HATCH MOTION ERROR
Dropping was stopped because one of the hatches had trou-
ble moving. An ignition sphere may have jammed the hatch. Try restarting to see if
the jam has been cleared. If the problem persists, land and inspect the hatches.
MOVE TIMEOUT
Dropping was stopped and disabled because one of the injection or
puncture motors had trouble moving. Dropping cannot restart until Ignis is power-
cycled. Land and inspect the injection and puncture motors. This message will only
appear on older versions of Ignis.
INJECTION A MOTION ERROR
Dropping was stopped and disabled because the
A-side injection motor had trouble moving. Dropping cannot restart until Ignis is
power-cycled. Land and inspect the motor.
INJECTION B MOTION ERROR
Dropping was stopped and disabled because the
B-side injection motor had trouble moving. Dropping cannot restart until Ignis is
power-cycled. Land and inspect the motor.
PUNCTURE MOTION ERROR
Dropping was stopped and disabled because the punc-
ture motor had trouble moving. Dropping cannot restart until Ignis is power-cycled.
This error could lead to an in-flight fire if Ignis was not able to remove an injected
sphere. Use the camera and temperature sensor to monitor for an in-flight fire and use
the emergency release in that event. Land and inspect the motor.
UNKNOWN ERROR
Dropping was stopped because of an error that the app did not
understand. Try to restart dropping. Check that you are using the latest version of
the app.
UNKNOWN HARD ERROR
Dropping was stopped because of an error that the app
did not understand, and cannot be restarted until Ignis is power-cycled. Land and
inspect Ignis. Check that you are using the latest version of the app.
If these troubleshooting steps do not resolve the issue, contact Drone Amplified for sup-
port.
The status is normally displayed with white text, but the status may become yellow or
red to emphasize errors. If the status is yellow, then Ignis is unable to start dropping. If
the status is red, then Ignis may have encountered a hard error that disables dropping until
Ignis is power-cycled. The status can also turn red if the temperature sensor is reading a
temperature above 60 degrees Celsius.
Last Updated March 12, 2020
Page 103
