Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Touch the connection option corresponding to the Ignis’s Bluetooth Address, which is
shown inside the battery compartment or on the back of the Hopper, to begin connecting to
Ignis over Bluetooth. This will open a screen similar to Figure 36. The status will initially
show “Bluetooth Disconnected” while the app is attempting to connect. Once it successfully
connects, which may take up to 10 seconds, the status will change to “Bluetooth Connected”.
Ignis’s status will be displayed once the app begins to receive messages from Ignis.
4.4.4 Ignis Battery Level
Ignis Battery Level
:
Greater Than 7.4V
Verify that the battery voltage is above 7.4V in the app (Figure 22). See Section 1.3 for
more information about the battery and power information.
4.4.5 Reservoir and Pumps
Reservoir and Pumps
:
Filled and Purged of Air
Figure 37: Refilling reservoir
Fill the reservoir by connecting the fill coupler and cranking the hand pump (see Fig-
ure 37).
If the reservoir was emptied during the last flight, you may need to purge air from the
pumps and tubing. Press and hold the button in the center of the status LED below the
syringe for 3 seconds, then release the button and the pumps will run forward for 3 seconds.
Repeat this procedure until antifreeze fills the tubes and reaches the needles.
4.4.6 Drone Preflight Inspection
Drone Preflight Inspection
:
Completed
Last Updated March 12, 2020
Page 48
