Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Figure 14: Left: Battery install location. Right: Locate battery all the way forward and to
the outside edge. Press to engage fastener.
Figure 14 shows the process for installing the battery. Start by opening aligning the
battery as close to the front and outside edge as possible. Press firmly until the fastener
engages which usually makes an audible and tactile click. Sometimes, a side-to-side rocking
motion while pressing helps engage the fastener.
4.1.7 Hopper Attached to Drone
Hopper Attached to Drone
:
Secured
Figure 15: Attaching hopper to Drone. Left: Remove thumb screws. Right: Attach to
drone.
Figure 15 shows the process for attaching the Hopper to the drone. Start by removing
the red thumb screws from the top of the Hopper as shown in Figure 15(left). Snap the
Hopper onto the rails of the drone, as shown in Figure 15(right), and slide it along the rails
to ensure that the Hopper is aligned with the center mass of the drone. Finally, reinstall
and lightly tighten the red thumb screws to secure the Hopper to the drone.
Last Updated March 12, 2020
Page 31
