DResearch GmbH – Configuration of the Hydra
IP
analogue DVR
2011-02-02
17
3.2
Video/Audio input
Note :
Please note that there aren’t any separate profiles for alarm and ring recordings
(available March
2011).
* Currently the labels aren’t displayed in the ImageFinderNX
Parameter
Definition of cameras und video inputs
Source
The audio and video inputs correspond to physically existing interfaces. There is an
individual view for every system – depending on the amount of inputs. This value is not
editable.
Label
The labels for the cameras can be set here. You should choose a camera label that can
be clearly assigned. The label is shown in the analysis software.* Avoid special
characters and umlauts. Should a label be changed, it is updated in the following tabs. .
Active (connected)
This parameter identifies if a camera is physically connected to the video input. Only
active cameras are considered for the configuration.
Monitor mirroring
With this parameter you determine if the camera signal is to be mirrored for the monitor
display. It should be noted that during recording the camera signals are always recorded
unmirrored, even if mirroring is enabled on the monitor.
Standard profile
Here a profile is chosen, with which you select the values (frame rate, quality, etc.) that
are used for recording the camera signal and audio signal respectively If there aren’t any
recordings to be made from the camera, select “no recording” here The profiles that have
been created in the lower section are shown in the selection list. There is a standard
profile for both audio and video available per default.
Configurable cameras at the video inputs. In this
illustration, the configuration of a Master/Slave system
MR306-6 is opened. In this case, the cameras of the
slave, on the right, are configurable. (Only with M/S)
Profiles for audio and video recordings. It is possible to
set up multiple profiles that can be then assigned to the
cameras in the camera definition selection.
