Troubleshooting
SECTION 06 Troubleshooting
32/54
■ Reassembly:
□ Solder the control wires to the new solenoid valve.
□ Connect the intake hose and slide the sleeve.
□ Fit new seals (two O-rings) to the new solenoid valve.
□ Position the solenoid valve in its housing (check that it is oriented correctly) then
retighten the nut.
□ Connect the rinsing hose.
□ Screw the two ground lugs back on.
□ Use solvent to clean the seal mating surface on the recovery assembly then replace
the seals (O-rings around pins) and replace it.
□ Use solvent to clean the seal mating surface on the 4 solenoid valve block then
replace the seals (two gaskets) and replace it.
■ Testing:
□ Restart the head before closing the rear cover. Check that there are no leaks.
□ A "stability check" is required.
