Troubleshooting
SECTION 06 Troubleshooting
34/54
Replacing the ink management module
■ Tools:
5 mm Allen wrench; 2.5 mm Allen wrench.
CAUTION:
Rinse and drain the printer then turn it off and unplug it from its AC
outlet.
If you are unable to use the automatic "Drain/rinse" function due to problems on
the ink circuit you may use the procedure below to drain the ink
management module manually.
■ Disassembly:
□ Open the right side door and remove the ink and additive cartridges.
□ Unscrew the two cartridge guide rods. Remove the cartridge support plate (two
screws).
□ Position the print head lower than the ink circuit.
□ Remove the hydraulic connector from the console without uncoupling it and place it
above a retention tray.
□ Uncouple the hydraulic connector. Place a stopper in the conduit side of the half-
connector.
CAUTION:
If the "drain/rinse" function has not been performed, take appropriate
precautions as a large quantity of residual ink may pour out
from the ink circuit side half-connector.
This ink will flow out of the buffer vessel by gravity.
