buts of the sway bar according to the described torque under the condition of non-loading.
Torque:
(c)
：
73N
·
m
7)Check and adjust the toe-in according to the manul.
6.Knuckle
Disassembly
1)Lift the vehiecle and remove the tyres.
2)Remove the wheel-hub. Refer to “Disassembly” of “Hub/ tyre bolt”
order 2)-8) from this section.
3)Remove the knuckle from the tie-rod.
4) remove the sppd-sensor from the knuckle(If there is).
4
5)Remove the ball joint from knuckle. And then loose
down the bolts of the bracket.
6)Remove the knuckle.
Fixing:
1)Fix the knuckle to the sway-ar and the stut. Match
the slots and the bolts well, and fix the bolts of ball
joint. Tighten the bolts and the nuts according to the
described torque below.
Torque
(a)
；
95N·m
(b)
：
55N·m
2)Fix the speed-sensor(If there is).
3)Cnnect the tie rod with the knuckle, and tighten the
nuts of the tie rod to the described torque below.3)
Torque
(c)
：
45 N·m
Attention
When tighening the nuts of tie-rod. Boost up the
end of tie rod with jack to stop the rotation of the
knuckle.
4)Follow the fixing order above. Take reference
from
”
wheel hub/wheel bolts
”
1)-7)
7.Bracket Of Strut7．
Disassembly
1)Jack up the vehiecle and remove the tyres.
2)Remove the swar-bar(L&R). Refer to “Disassembly Of
Sway Bar” of this section
3)Remove the fixing-bolts of turning-gear box.
4)Remove the wire-harness of speed-sensor.(If there
is)
5)Remove the bracket of the strut.
1)Fix the bracket of the strut and tighten the bolts to the described torque.
Torque
(a)
：
95 N·m
