The oil which is out of date, used or not served in the unsealed container is not allowed.
Replacement
Change the oil as per the following requirements.
Drain out all the oil of the brake system and add the oil recommended above, then exhaust the air.
The air exhaust process refers to chapter 6.
Brake pedal
Inspection
Check the stroke of the brake pedal.
Checking process refers to chapter 6 “brake pedal stroke inspection”.
Brake handle and cable
Inspection
. Check the teeth top of the brake handle is whether injured or abraded. If it is,
you should change the stop brake handle.
. Check the operation and stroke of stop brake handle is correct or not. Adjust it if it needs.
The processes of checking and adjusting refer to chapter 5 “stop brake check and adjust”.
“a”: the stroke of stop brake handle.
4-7 teeth(under 20kg pull power).
7. Chassis and body
Clutch
Inspection
Check the free stroke of the clutch pedal. The processes of checking and
adjusting refer to unit 2 of chapter 6.
“a” free stroke of pedal
10—15mm
Tire
Inspection
1)
Check whether the tire is worn or damaged too much. If it is,
change it.
2)
Check the inflating pressure and adjust the pressure according to the
technical requirement when it is needed.
Caution:
. The tire inflating pressure checking should be after the tire is cooled
down.
. Find out the specified tire inflating pressure in the complementary logo of
tire inflating pressure or operation handbook.
Change tires in turn
Details please refer to section 3 of chapter 4.
Tire
Check the spoke of wheel rim
Check whether there is pressed mark, distortion and crackle on the
wheel. If the rotary table seriously destroyed, it needs to change.
Inspection of wheel bearing
1) Check the front wheel bearing to see whether it is abraded, damaged
or has abnormal noise or Kata noise. Details as per section 1 in
1. Clutch pedal
1. worn sign
1. Front tire
2.
Rear tire
3.
Spare tire
