Chapter 4 “front suspension inspection”.
2) Check the rear wheel bearing to see whether it is abraded, damaged or has abnormal noise or Kata noise. Detail
as per section 1 in Chapter 4 “rear suspension inspection”.
Wheel nut
Check the wheel nut is tight or not. If not, tighten it according to the specified torque.
Suspension
Inspection
. Check the front/rear shocker absorber to see whether it has leakage of oil, pressed marks or other damages of the
bush. And check it to see whether it has damages, if yes, change them.
. Check the front/rear suspension to see whether it has damages, loosed or missing parts and check whether the
parts is abraded or not well lubricated. If yes, maintain or change it.
. Check the front boll end sealing washer to see whether it leaks, looses, cracks or has other damages. If it has,
change it.
. Check the front suspension nut and bolt to see whether they are tight. If needed, tight them again, and if there is
damaged parts, maintain or change it.
Propeller shaft
Inspection
1)
Check the propeller shaft and universal joint and the spline to
see whether they have Kata noise. If there is, change the
damaged parts.
2)
Check the propeller shaft flange nut and bolt is tight or not. If
needed, tighten again.
Tightening torque
(a): 50N.m
Replacement
1)
Balance the car. Take away the oil drain-out plug, drain out the oil.
2)
Smear the oil drainer with sealing mucilage then tighten the oil drainer according to the specified torque.
3)
Add the specified oil to the oil hole.
4)
Tighten the oil filler plug. The recommended oil, oil quantity, and tighten torque refer to unit 1 “cars
maintenance” of chapter 3.
Check
1) Check differential gear shell whether there’s leaking information, if yes, please repair it.
2) When inspecting the oil level, the vehicle should be laid down in smooth place.
3) While removing the oil level line plug of differential gear, you
can check the oil level through the plug hole.
When removing the fuel level line plug , if oil outflows from
the hole or the oil level is equal to the hole, the oil level is ok.
1. Supporting pole
1.Dust-proof sealing gasket
2.Suspending arm
