DL JCPT-HD/DC Series, Training Manual

Page: 62 / 119

培训手册
Training Manual
传感器设定及称重标定
Sensor Setting and Load Calibration
JCPT-HD/DC
www.cndingli.com
6-2
1.
传感器设定（
Sensor Setting
）
1.1
水平传感器设定（
Tilt Sensor Set State
）
 新款水平传感器设定（
New Tilt Sensor Set State
）
水平清零步骤（
Set Zero Steps
）
1)
将机器行驶到水平的地面上。（
Drive the machine to the level ground.
）
2)
找到传感器的侧面的清零按钮
“SET ZERO”
，按住按钮，直到传感器上的这个指示灯红绿交替
闪烁。（
Find there set button“SET ZERO”on the side of the sensor,press and hole on the
button, the indicator light on the sensor until the alternating red and green flashes.
）
3)
连续再按三下传感器上的清零按钮后，指示灯闪烁停止，传感器上绿灯常亮，传感器清零工作
完成。（
Continuous press three times with the “SET ZERO” button, lights stop flashing, the
green light on, the sensor set zero is finished.
）
报警角度设置步骤（
Set Alarm Angle Steps
）
长按角度设置按钮
7
秒，等到角度设置的
4
个灯全部亮一下后，
3
秒内按一下角度设置按钮根据所
需进行设定，哪个灯亮即为哪个角度，设置完成后
4
个灯全部点亮且
3
秒后显示当前的倾斜报警角
度。（
long press the angle to set the button for about 7 seconds, at this time, four LED lights are
all bright, and in 3 seconds, press set button choose A,B,C and D alarm angle as you want,
select the angle option 3 seconds after the A/B/C/D four LED lights are fully lit and return to
current setting alarm angle.
）
注：请参照机器铝牌设定机器倾斜报警角度。（
Note
：
Please refer to the machine aluminum
plate set the alarm angle.
）