DL JCPT-HD/DC Series, Training Manual, Page: 23 / 119

培训手册
Training Manual
元器件介绍
Parts Introduction
JCPT-HD/DC
www.cndingli.com
4-5
7
充电器
Charger
给机器上的电池充电。机器在充电过程中切断控制回路里
的总电源。
To charger the batteries; the control power will be cut off
when charging.
8
过电压保护器
Charger protector
与老款充电器搭配。确保输入充电器的电压稳定在
190V-
270V
，保护充电器因电压不稳而损坏。
Only for old version chargers. Select the input voltage to
charger is between 190V-270V which for protect the
charger is not been damaged by wrong voltage.
9
压力传感器
Pressure sensor
实时监测剪叉起升的压力，并配合剪叉上的角度传感器，
来实现超载报警并限制起升状态行走和起升的功能。
Check the hydraulic pressure when you lift the scissor all
the time;together work with angle sensor in scissor stack
to get overload function which to limit drive and lift
function in elevated position.
10
上限位开关
Up limit switch
右边，起升最大位置限制开关。
Right side,The maximum limit switch for lift; to cut off the
lift function if activitied.
老款
old
version
新款
new
version