DirecTV R10, User Manual

Page: 25 / 165

15
1
S e t u p E x a m p l e s
Before adding a VCR, see page 10 for Basic Setup instructions.
The DIRECTV ® DVR has two sets of
A/V Output
jacks. You may have used one set
(labeled Output 1) when you completed the Basic Setup steps on page 10. You can
connect a VCR using the other set (labeled Output 2).
���
Connect a Composite A/V cable from the DVR’s
A/V Output 2
jacks to the
A/V Input
jacks on your VCR.
If your VCR only has
RF
jacks, connect a Coaxial RF cable (not supplied) from the
DVR’s
RF Out
jack to the
RF In
jack on the VCR.
���
Connect a Composite A/V cable from the
A/V Output
jacks on your VCR or DVD
recorder to another set of
A/V Input
jacks on your TV.
If your TV only has an
RF In
connector, connect a Coaxial RF cable (not supplied)
from the VCR’s
RF Out
jack to the
RF In
jack on your TV.
To watch a video tape, change your TV’s input setting by pressing the INPUT, SOURCE,
or TV/VIDEO button on your TV’s remote control until the correct input is displayed. If
you have trouble changing your TV’s input setting, consult your TV’s owner’s manual. If
you need help, see page 107.
To save recordings from your DVR to a video tape, use the “Save to VCR” feature. See
page 75 for more information.
If you use Coaxial RF cables in
steps
���
and
���
, you must set the
Channel 3/4 switch on the back of the
DVR to match the switch on the back of
your VCR. Then tune your TV to the same
channel (3 or 4) to view the signal.