DirecTV R10, User Manual

Page: 109 / 165

99
6
R e m o t e C o n t r o l S e t t i n g s
3. Point the remote control away from the DVRs, and cover the front end of the remote
with your hand. Press and hold the PAUSE and DIRECTV buttons until the red light at
the end of the remote control comes on and stays on when you release them.
4. Point the remote control at the DVR for which you want to set the remote address, and
press the number “1.” Press the RIGHT arrow. On the screen, the “Remote Address”
changes to 1. Exit System Information by pressing the DIRECTV button.
5. Repeat steps 1-4 on the second DVR and its remote control, pressing the number 2 for
the second remote address.
The remote controls are now set to send signals exclusively to the DVR for which they are
addressed. You may want to label the remote controls so that you remember which DVR
each one controls. Addresses 1 to 9 are unique. Zero (“0”) is a universal remote address,
meaning a remote set to address “0” will try to control any DVR that receives its signal.
If you do not exit System
Information before you go to
step 5, you may transmit information to
the original DVR and overwrite the first
address you entered.
DIRECTV Central Messages & Setup Settings Remote Control