DirecTV R10, User Manual

Page: 107 / 165

97
6
R e m o t e C o n t r o l S e t t i n g s
2.
Enter the search code.
Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
After you press the fourth digit of the code, the red light on the end of the remote
control will flash twice, then remain on.
3.
Test the remote control.
Point the remote control at the TV or A/V receiver. Press
CHAN UP. The test is successful if the TV or A/V receiver responds (by powering off,
changing input, or muting, depending on the function you are trying to program). If
there is no response, wait two or three seconds, then press CHAN UP again. Continue
doing this until the TV or A/V receiver responds.
When the TV or A/V receiver does respond, press ENTER to select the current code.
The red light at the end of the remote control will flash three times to indicate that the
remote control is properly programmed to control your device.
When the red light on the end of the remote control turns off, you have reached the end
of the available codes.
Unfortunately, due to the great variety of TVs and A/V receivers, some makes and
models are not compatible with your DVR’s remote control. If you reach the end of the
available codes without finding a code that works with your device, you will need to
use your TV or A/V receiver’s remote to turn those devices on and off, and to control
the volume.
To Test:
TV power, volume,
and muting
TV input A/V receiver power,
volume, and mute
A/V receiver volume
and mute only
Enter:
0999 0999 1999 1999
DIRECTV Central Messages & Setup Settings Remote Control