Digital Projection POWER 2v, User Manual

Page: 22 / 174

Analogue Input Board
The Analogue Input Board located at the rear of the projector provides all the
required connections for video, computer, audio and remote control inputs. The
input board is split in three main sections - Power, Source and Control (see below).
POWER
Mains Input - For connection of 200 - 240 V ac 50 - 60 Hz.
Circuit Breaker (On/Off Control) - Combined on/off switch and circuit isolator
(in case of system overload).
SOURCE
Inputs 1, 2, 3 - Each of these inputs can be configured for different signal sources.
RGB, Hs Vs and Hs+Vs are used with a computer input, Composite/G is used with
a composite signal (such as NTSC), C and Y (S-VIDEO) are used with a VHS
video player and Y Pr Pb are used with Betacam or component sources.
Select LED's - The input card LED's indicate which input should be used with the
current channel. If the projector cannot find a valid signal, the LED flashes.
AÑ12
Overview
OVERVIEW
LBV00018; Revision E - 28/01/98
Component
S-Video
Composite
INPUT 2
INPUT 1
INPUT 3
Audio
Switcher
Video
Switcher
Ext
Remote
Component
S-Video
Composite
R/Pr
C
-
G/Y
-
CVbs
B/Pb
Y
-
H/HV
-
-
V
-
-
Out In
Computer
200-240V AC 16A Max
50/60 Hz
Digital Projection Limited, Manchester M24 1XX UK
Tel: +44 (0)161 681 6500 Fax: +44 (0)161 684 7674
POWER SOURCE CONTROL
Infra Red
Receiver
Power
Section
Source
Section
Control
Section
WARNING
This equipment
must be earthed