Digital Projection POWER 2v, User Manual

Page: 150 / 174

Satellite Receiver
The Satellite Receiver requires two cables, one to connect the Remote Control to
the Satellite Receiver and one to connect the Satellite Receiver to the Projector. The
signal between the Remote Control and the Satellite Receiver is Phillips RC5 and
the signal between the Satellite Receiver and the Projector is RS232.
The cable between the Remote Control and the Satellite Receiver can be up to 10
metres in length and requires a 3.5mm stereo Jack Plug at the remote control end
and a 4 pin LEMO connector at the Satellite Receiver end.
The cable between the Satellite Receiver and the Projector can be up to 60 metres in
length and requires a male 15-pin High Density ‘D’ type connector at both ends.
DÑ42
Advanced User Information
Cables & Connections
ADVANCED
LBV00018; Revision E - 28/01/98
Remote Control End
Screen
Centre
Tip
Signal
+15V
Signal
Ground
Sense
Satellite Receiver End
Pin 1
Pin 3
Pin 4
Pin 2 to Pin 4
Conductor
White
Blue
Screen
Wire Link
Satellite Receiver End
Pin 1
Pin 5
Pin 15
Signal
+15V
Signal
Ground
Projector End
Pin 1
Pin 5
Pin 15
Conductor
White
Blue
Screen
TIP
CENTRE
SCREEN PIN 1
PIN 2 PIN 3
PIN 4 PIN 1 PIN 5
PIN 15
3.5mm SCREENED
STEREO JACK PLUG
4 WAY 'LEMO'
CONNECTOR MALE 15-PIN HIGH DENSITY
'D' STYLE CONNECTOR