Digital Projection POWER 2v, User Manual

Page: 151 / 174

Projector End
Pin 2
Pin 3
Pin 5
Signal
TX
RX
Ground
Computer End (9-pin)
Pin 3
Pin 2
Pin 5
Computer End (25-pin)
Pin 3
Pin 2
Pin 7
✍
PIN 2 PIN 5
FEMALE 9-PIN 'D' STYLE CONNECTOR
PIN 5 PIN 2
MALE 9-PIN 'D' STYLE CONNECTOR
PIN 3 PIN 3
Remote Computer Control
The projector end of this cable must be fitted with a ‘male’ 9-pin D-type connector.
If using a ‘laptop’ computer, the other end of the cable should be fitted with a
‘female’ 9-pin D-type connector (or a ‘female’ 25-pin connector). The cable should
be a screened cable with a minimum of three cores including the screen. The
following pins should be connected:-
On the Computer Out connection the RX and TX signals are reversed.
Switcher Control
The connection requirements for the projector end of the switcher control cable are
identical to that for remote computer control. For information on the switcher end of
the cable, please refer to the documentation supplied with your switching device.
DÑ43
Advanced User Information
ADVANCED
LBV00018; Revision E - 28/01/98