Digital Projection POWER 2v, User Manual

Page: 100 / 174

Multiple projectors are used to produce a brighter image, to join up two or more
images or to display two or more images side by side.
When using multiple projectors it may be necessary to control all projectors at once,
or to operate an individual projector. This is achieved through the use of the Infra-
red remote control or a computer.
Each projector has its own unique address which is set using the remote control or a
computer (see Set Projector Address, C—35 & Computer Control, opposite). The
remote control can operate up to 32 projectors and a computer is capable of
operating up to 256.
The 'A' button on the remote is used to send a command to all operating projectors,
or to an individual projector, see examples below.
To activate only projector #1:
1. Press 'A' twice.
2. Press '1'.
3. A message box will appear stating- 'Projector Address is 1'.
4. Use control buttons to operate projector #1.
To address all of the projectors:
1. Press 'A' twice.
2. Press '0' (zero is the global address).
3. Use control buttons to operate all projectors.
You must press the 'A' button twice within three second in order for the function
to be recognised and the function will be automatically de-selected if you do not
issue any commands within 10 seconds.
All of the remote commands, apart from 'A', can be global or individual. If you use
the remote for an individual projector, you will need to make sure that only that
projector receives the command.
CÑ48
System Operation
Addressing Multiple Projectors
OPERATION
LBV00018; Revision E - 28/01/98
✍