Digital Projection POWER 2v, User Manual

Page: 15 / 174

Pre-Installation Check
Before mounting the projector in its intended location, the following pre-installation
routine must be performed:
1. Install the projector lens.
2. Ensure all the air flow inlet and outlet ducts are clear from obstruction.
3. Insert the power cord securely into the socket on the rear panel of the projector
and connect to an appropriate mains supply (refer to the specification label at
the rear of projector).
4. Switch on the projector and wait for approximately 30 seconds.
5. Check air is flowing out of the exit ducts on the top and left hand side of the
projector.
6. With the screen or a wall illuminated, confirm the Menu System is operational
by pressing OSD ON then MENU on remote control (a main menu should be
clearly visible).
7. Turn the lamp off by depressing the LAMP OFF button on the remote control
for two seconds.
8. Power down the projector and disconnect from the mains supply.
9. Continue with the system installation.
AÑ5
Overview
Initial Preparation
OVERVIEW
LBV00018; Revision E - 28/01/98