Digital Projection POWER 2v, User Manual

Page: 16 / 174

Remote Control Unit - Battery Installation
The Remote Control Unit can be powered by 4 AAA (HP16/RO3/LR03) alkaline
batteries or by direct connection to the projector via a remote receiver.
The battery compartment is located on the back of the
Remote Control. To remove the compartment cover,
insert a finger-nail into the recess provided to the right
of the cover and push to the right. While pushing to the
right, lift out the left hand side of the cover.
Insert the first two new batteries as shown below and
slide them to the back of the compartment. Insert the
remaining two batteries by pivoting them against the
electrical contacts and pushing down into place.
When the batteries are securely in place, replace the cover by aligning the stays on
the right hand side and pushing down the left hand side until it 'clicks' into place.
AÑ6
Overview
OVERVIEW
LBV00018; Revision E - 28/01/98
-
+
-
+
-
+
-
+
+
-