Digital Projection HIGHlite 12000Dsx+ User Manual Download

Page: 61 / 90

E-61

Lens Shutter on During Signal Switching

While switching the signals (screen image is muted), the light
can be absolutely shut out from the lens simultaneously with
shutter.

With Check Mark ................. While switching the signals and

muting the images, shutter is
simultaneously activated.

Without Check Mark ............ While switching the signals and

muting the images, shutter is
deactivated.

3D Sequence Set Select

Use when displaying 3D images using a single projector OR
signals with a high refresh rate with motion video content.
This function optimizes the appearance of greyscale tones for
3D sources and signals which have high vertical frequencies.

Turn-on 3D Sequence Set Select for signals with a vertical
frequency between 75 Hz and 96 Hz AND when Synchronise
function is On.

Turn-off 3D Sequence Set Select for all other input frequen-
cies OR when Synchronise function is Off.
- Also set Synchronize ON.

(To set Synchronise ON see page E53.)

CAUTION
• Relationship between [Synchronize], [Input signal verti-

cal frequency] and [3D Sequence]

• When [3D Sequence] setting does not fit the setting above,

greyscale tones will not be smooth.

• When operating within shaded box conditions and using

the optional MM-WARP, signals cannot be displayed in their
native resolution, they must be resized.

[Page 4]

Selecting Communication Speed [Communication Speed]

This feature sets the baud rate of the PC CONTROL port (D-
Sub 9 Pin). It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for
your equipment to be connected (depending on the equipment,
a lower baud rate may be recommended for long cable runs).

Enabling and Disabling Projector ID

Each Projector needs its own unique addresses when used in
serial communication mode. You can choose one of 64 unique
address using the spin box. First select Enable. Keep press-
ing

button increases the number. To make your setting avail-

able, select OK.

Assigning Projector IDs

You can operate multiple projectors with the same remote con-
trol.
To do so:

1. Select “Projector ID” and assign an ID number to each pro-

jector.

2. Select the same communication speed for both the projec-

tor.

3. On the remote control specify the ID number of the projec-

tor to be adjusted. Press and hold the CTL and press MENU
(ADDRESS) button to enter the ID number.
You can operate the switcher assigned the same ID number
as the remote control.

NOTE: Specifying "None" for Projector ID allows you to operate multiple projectors
concurrently. However, some projectors may not synchronize to the other projec-
tors.

Selecting Default Source [Default Source Select]

You can set the Projector to default to any one of its inputs
each time the Projector is turned on.

Last ............. Sets the Projector to default to the previous or

last active input each time the Projector is turned
on.

6. Using On-Screen Menu

98 < Vf 120

Synchronize

Input Signals of Vertical Frequency Vf (Hz)

24 Vf 75

75 < Vf 96

Turn-off 3D Se-
quence setting

OFF