Digital Projection HIGHlite 12000Dsx+, User Manual

Page: 27 / 90

E-27
2. Installation
Connnecting the Power Cable
After making certain that the main power switch of your projector is OFF, connect the power cable to a 200 to 240 VAC three-prong
outlet (grounded).
Two versions of the projector are available: USA models are supplied with a Hubbel type connector, for Rest of World a CEE-Form
connector is supplied.
CAUTION
• Please contact your dealer / distributor to perform the wiring for connection of the power cable to your projector.
• Be sure to ground the equipment to ensure safety.
To avoid electric shocks, request a professional to carry out the grounding.
Be sure to perform earth connection before inserting the power plug into the wall outlet.
NOTE:
• When disconnecting the power plug, first set the projector to the standby mode, and then turn off the main power switch before disconnecting the power plug.
Disconnecting the power plug or turning off the main power switch without first setting the projector to the standby mode may result in the values that were set with the
on-screen menu and other settings not being stored within the projector.
• Do not disconnect the power plug from the outlet in circumstances such as the following:
* While the hourglass icon is displayed.
* While a message to the effect of “Please wait a while” is displayed. (This message will be displayed if the power has been switched off.)
* Immediately after the main power switch has been turned ON. (When the POWER indicator is not lit in orange, and before “Stand by” is displayed on the liquid crystal
display screen.)
* Immediately after the end of the cooling down period (during which the fan is running for 3 minutes after the POWER button has been switched OFF, and before “Stand
by” is displayed on the liquid crystal display screen).
200-240 VAC
three-prong outlet