Digital Projection HIGHlite 12000Dsx+, User Manual

Page: 25 / 90

E-25
Installing Additional Option Boards
Four types of option boards are available for the Projector.
Please purchase as required.
1. Turn off the main power switch of the Projector.
Warning
Ensure main power is disconnected or by turning
off the main power switch before installing or re-
moving the board from the Projector. Failing to do
so could result in electrical shock.
2. Use a flat-bladed screwdriver to loosen the 2 screws of the slot panel
located at the input terminals portion of the Projector, then remove the
screws and panel.
The example shown in the drawing is the MM-SDI board.
NOTE: When inserting the board into the slot, insert it so that it moves along the
rails located at the right and left of the slot. If the board is not positioned be-
tween the rails the connector will not be engaged and the board will not be
operational.
rail
2. Installation
NOTE:
• Keep the removed screws and panel in a safe place.
• Please do not use the Projector while the panel is disengaged. Foreign matter
could enter the interior and cause breakdown.
3. Insert the board into the slot.
NOTE: The following 4 types of option boards can be inserted in the Projector.
Multiple option boards of the same model can also be inserted.
* MM-VIDEO(See page E-15)
* MM-RGB(See page E-15)
* MM-DVI(See page E-16)
* MM-SDI(See page E-16)
4. Tighten the 2 screws located at right and left of the board and fasten
securely.