Restoring the System,
Continued
Run SHOW
CONFIG
Command
To run the SHOW CONFIG command, complete the following
steps and refer to Example 3–1.
Step
Action
1
Press the Halt button located behind the door in the front
of the system box.
Results: The system displays the console prompt on the
screen.
2
Enter
SHOW CONFIG
at the console prompt and press
Return
.
>>> SHOW CONFIG
Return
3.
Verify the Ethernet hardware address. The address must
be the same as the one recorded before the upgrade
began. Refer to the section
Preparing VAXstation
Model 60 for Disassembly
for more information.
4.
Verify that the SPXg/gt diagnostic ROM is Version 1.2 or
higher.
Note
The TURBOchannel adapter module and options are not
tested by test 100. For more information, refer to the
VAXstation 4000 Model 90 Service Information Guide
.
Run the
System
Exerciser
Verify that all devices are interacting properly by using the TEST
100 command to run the system exerciser.
3–22
