Removing MS44 Memory SIMMs
Cautions
Memory components can easily be damaged by static
electricity. An antistatic wrist strap must always be worn
when removing or installing memory components.
Memory modules must always be removed starting from
the rear of the module. You must remove any modules at
the back of the board and work toward the front of the
board. Memory modules are numbered on the right edge of
the memory connectors located on the system board.
Failure to release the two module retainers will
permanently damage the module connector located on
the system module.
Remove the
MS44 Memory
SIMMs
To remove the MS44 memory SIMMs located on the KA46 system
module, complete the following steps and refer to Figure 2–3.
Step
Action
1
Release the two metal retainers at each end of the
memory SIMM connector.
2
Rotate the memory SIMM back approximately 55 degrees
to the rear of the unit.
3
Lift the SIMM out of the slot.
4
Place the MS44 memory SIMM on the antistatic mat.
Continued on next page
2–22
