Chapter 4 – Transfer Screen Data
4-4
GLC2400/2500/2600 Series User Manual
The GLC2000 Series unit is equipped with the Ethernet I/F which allows you to
set up the GLC via an Ethernet network, as well as transfer GLC screen data.
When using the Ethernet communication protocol, you must specify
the port number for the protocol as +10 or higher than the value speci-
fied in this section. Otherwise, the setup or screen data transfer via
Ethernet is disabled.
After you connect an Ethernet cable to the GLC’s Ethernet I/F, the GLC will
appear on the Ethernet network.
Transferring Data to a Completely New GLC
Setting Up the IP Address Manually
Touch the Ethernet Settings button on the Initial Start Mode screen.
6.5.4 – “ETHERNET SETUP”
Setting Up the IP Address Automatically
It is not necessary to select Ethernet Settings on the Initial Start Mode screen.
When the options for Ethernet Settings are not specified, they are set automati-
cally.
If you choose to set the IP address automatically, specify the IP address of the PC
in the range of “10.255.255.1” to “10.255.255.254” and the subnet mask as
“255.0.0.0.”
Transfer data using the screen creation software package.
GP-PRO/PBIII for Windows Operation Manual
(included with the
screen creation software package)
4.2
Ethernet Data Transfer