Chapter 6 – Initializing the GLC
6–16
GLC2400/2500/2600 Series User Manual
CONTRAST ADJUSTMENT
This setting is not available with the GLC2000 Series.
BRIGHTNESS ADJUSTMENT
When
BRIGHTNESS ADJUSTMENT
is set to ON, you can adjust the brightness by
touching the GLC unit’s screen. To enter
BRIGHTNESS ADJUSTMENT
mode,
press the screen’s bottom-right corner (screen A, position 1, below), and then
touch the bottom-left corner (position 2). When the
BRIGHTNESS ADJUSTMENT
screen (B) appears, touch the bar’s left side to brighten the display, or the right
side to dim the display. Four levels of adjustment are available with this unit.
•
To exit the BRIGHTNESS ADJUSTMENT mode, touch any-
where above the Brightness Adjustment bar.
•
You cannot enter the BRIGHTNESS ADJUSTMENT mode
while the GLC is starting up.
•
BRIGHTNESS ADJUSTMENT settings can be made dur-
ing RUN mode (PLC<-->GLC communication).
USE TOUCH PANEL AFTER BACKLIGHT BURNOUT
This option allows the user to enable [ON] or disable [OFF] the touch operation
when the backlight burns out. Setting this item to [OFF] prevents the GLC from
sending input signals to the PLC.
When the Backlight Burns Out:
•
The Status LED’s orange light will turn ON.
•
The System Data Area’s Status bit 10
*
1
will turn ON.
•
If the SYSTEM RESET item is set to ON, only SYSTEM
RESET can still be performed by touch operation.
•
If the GLC is in OFFLINE mode, the touch-panel operation
will become enabled, regardless of the settings.
Normally, the unit detects backlight burnout by monitoring the current.
However, depending on the problem with the backlight, the unit may fail
to detect this condition.
Bright
Dark
2
1
A
B
1.
Bit +6 (when using the Direct Access method), and bit +11 (when using the
Memory Link method), will turn ON.
GP-PRO/PBIII for Windows Device/PLC Connection
Manual
(included with screen creation software)