Chapter 6 – Initializing the GLC
6–20
GLC2400/2500/2600 Series User Manual
SCANNING MODE
Set the
SCANNING MODE
according to your scanner’s settings.
The communication format for each mode is shown below:
• DEFAULT
• DENSO QR code scanner
• TOHKEN Code scanner
The following setting varies depending on the communication protocol for the
Expansion Serial Interface being transferred.
This section explains the case where
SERIAL CODE READER
(
LS
) is transferred.
Use this setting when a serial code reader is connected to the Expansion Serial
Interface to read serial code data.
Header
(STX)
Code mark
(7 bytes)
No. of digits
(4 bytes)
Code data
Terminator
(CR)
BCC
(7 bytes)
Code
data
Terminator
(CR)
Header
(STX)
Code
data
Terminator
(CR + LF)
6.4.7 EXPANSION SERIAL ENVIRONMENT SETUP