3–19
Chapter 3 – Installation and Wiring
GLC2400/2500/2600 Series User Manual
Pin number
Signal Name
1
AUXCOM
2
AUXRESET
Pin number
Signal Name
3
TR+
5
SLD
6
TR+
Pin number
Signal Name
7
TR-
10
SP OUT
8
SLD
11
GND
Pins used for External Reset:
4
TR-
Pins used for Sound Output:
Pins used for Flex Network:
3. Make sure that each line (cable) is
inserted completely.
4. Retighten the two (2) set screws.
•
Use a small screwdriver (thickness 0.4 mm, tip width 2.5
mm) to tighten the set screws.
•
The recommended torque for tightening the set screws is
0.2 to 0.4 N•m.
•
If wire ends are not carefully twisted, strands from adja-
cent wires or contact with an electrode may cause a short
circuit.
5. Reattach the screw lock terminal
block to the GLC.
Be sure that all lines (cables) used are held securely in a cable clamp.
This clamp should be located near the rear of the GLC. Do NOT use
excessive force to tighten the wire set screws.