Chapter 8 – Maintenance
GLC2400/2500/2600 Series User Manual
8–6
8) Connect the backlight's one (1) power
connector. Next, close the circuit board
and secure the rear case in place using
the attachement screws removed in steps
1), 2) and 3).
5) Disconnect the backlight's one (1) power
connectors.
6) Loosen the backlight unit attachment
screw. Next, slide the backlight in the di-
rection shown and lift it forward and re-
move it from the GLC.
7) Insert the new backlight in the GLC. In-
sert the unit by sliding it in the direction
shown in step 6), then, tighten the unit’s
attachment screw.
• Be sure not to pinch or cut any of
the GLC unit's internal wiring when
closing the case.
• If any of the attachment screws be-
comes misplaced, check to be
sure that they have not fallen in-
side the GLC. If a screw has fallen
inside the GLC, do not connect the
unit’s power cord until it has been
removed.
Connector