6–29
Chapter 6 – Initializing the GLC
GLC2400/2500/2600 Series User Manual
MY IP ADDRESS
Sets up the GLC unit’s IP address. The IP address is 32 bits and designated in four
8-bit units, entered in decimal.
To use Ethernet networking, click on [Initial Settings], [PLC
Setup], [PLC Setup] and [Ethernet Setup].
SUBNET MASK
Sets the subnet mask. If you are not using a subnet mask, enter
“0.
”
To use Ethernet networking, click on [Initial Settings], [PLC
Setup], [PLC Setup] and [Ethernet Setup].
MY PORT NO.
Sets the 2-Way Driver Port No. using a value from 1024 to 65535. Starting from
the value entered here, a total of 10 consecutive ports can be used. The default
setting is [8000].
To use Ethernet networking, click on [Initial Settings], [PLC
Setup], [PLC Setup] and [Ethernet Setup] and select the cor-
responding Ethernet protocol Port No.
GATEWAY
Sets up the gateway’s IP address. Only a single gateway can be set up. If you are
not using a gateway, enter
“0.
”
6.5.4 ETHERNET SETUP
•
Enter the ETHERNET SETUP settings after receiving information from
your network’s system administrator.
•
Be sure to enter a unique IP address, not one used for other GLCs or by
the host.
This menu is for Ethernet settings. This information is used as setting data during
GLC setup or screen transfer, or, if the Pro-Server software is used, for the 2-Way
Driver.