Chapter 3 – Installation and Wiring
3–18
GLC2400/2500/2600 Series User Manual
Use the following steps to connect the speaker.
•
Be sure to tape or put a plastic tube over the shield line.
•
Do NOT solder the wire. Doing so could result in a bad or poor contact.
2 5 t o 3 5
[ 0 . 9 8 t o
1 . 3 8 ]
6 to 8 [0.24 to 0.31]
Blue(TR+)
White(TR-)
Shield (SLD)
* Do NOT solder end
Unit: mm [in.]
2. Loosen the corresponding pin’s set
screw and insert the cable.
The following procedures are used when connecting the
Sound Output terminals.
3.6.1 Cable Preparation
Remove the wire’s external covering and insert the center strand into the connec-
tor opening
3.6
Connecting to the Screw Lock Terminal
Use the following procedure to connect the External Reset, Flex Network, or
Sound Output to the Screw Lock Terminal.
3.6.2 Terminal Connetion
(The illustration shows a GLC2500/GLC2600
unit. The procedure, however, is the same as it
is for that of a GLC2400 unit.)
1. Rotate the screw lock terminal block’s
two (2) levers downward, as shown,
and remove the screw lock terminal
block.