105
Appendix F: Hard Drive Installation
5. Turn the unit over and tighten the hard drive screws.
6. Turn the unit back over and connect the SATA power and data cables to the hard drive.
7. Replace the cover and cover screws. Make sure to slide the lip on the cover under the bottom
of the front panel.
NOTE:
After installation, you must format the hard drive in order to use it with the system. See
“Formatting the Hard Drive” on page 107.
Removing the Hard Drive
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the screws (4x) from the back panel. Slide the cover back and up to remove.
Make sure that the system is OFF and ALL power adapters have been
disconnected before removing/installing the hard drive.
Summary of Contents for DNR200 Series
Page 49: ...39 Using the Main Menu...
