Services
Use the iPerf service
IX14 User Guide
427
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service iperf acl zone end
value
Where
value
is a firewall zone defined on your device, or the
any
keyword.
Display a list of available firewall zones:
Type
... firewall zone ?
at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Example performance test using iPerf3
On a remote host with iPerf3 installed, enter the following command:
$ iperf3 -c
device_ip
where
device_ip
is the IP address of the IX14 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
Transfer
Bandwidth
Retr
Cwnd
