Dickey-John Control Point, Operator'S Manual

Page: 46 / 109

OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
KEYBOARD PROGRAMMING / 41
12V BOOM SWITCHED OUTPUT
Select F12 to return to the Misc Menu and select the MORE MENU screen
pressing the 4 key.
The 12 Volt Switched Output provides a 12V output signal for a valve driver
to control a boom shut off relay. The default value for Switched Output is
NO. Connect the valve driver to the main harness lead labeled Switched
+12V. For earlier versions of Control Point® harnesses, connect the valve
driver using the adapter harness (466492040S1) connecting the switched
12V drive signal to pin 9 of the 16 pin granular valve connector.
Figure 28
12V Boom Switched Output Screens
The 12V Boom Switched Output functionality varies for different versions of
the hardware console.
To Verify Software Version:
Press Miscellaneous (F12), Service Menu (5), Display Software Version (2).
Any consoles with no hardware version number indicated or the version is
found in a different location than described above is also a Version 1
software.
Hardware Version 1 consoles require the following conditions for the 12V
Boom Switched Output to function correctly:
– All granular channels disabled.
– If Boom 5 is configured to utilize an anti-ice/pre-wet switch, the
switch must be in anti-ice mode.
– Anti-ice only mode.
Hardware Version 2 consoles require a liquid channel to be enabled for the
12 Boom Switched output to function correctly.
12V BOOM SWITCHED OUTPUT
ENABLED NO
No Boom Switched Output
Boom Switched Output
12V BOOM SWITCHED OUTPUT
ENABLED YES