Dickey-John Control Point, Operator'S Manual

Page: 14 / 109

OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
SYSTEM INSTALLATION / 9
SYSTEM INSTALLATION
The Console mounts on the vehicle dashboard or other surface suitable for
operator viewing using a U-bracket. The standard (combination) mounting
plate secures the Switch Module immediately to the left of the Console. An
optional mounting plate mounts the Console only.
The Switch Module cable, which plugs into the Console, is long enough to
allow the Switch Module to be placed near the vehicle seat or elsewhere for
operator convenience. If the combination mounting plate is used, the option
remains to later remove the Switch Module from the mounting plate and to
relocate it for convenience.
The system main harness is laid out and connections are made to the
sensor and actuator cables, battery, ignition switch, and additional options
(two-speed axle, hopper level sensor, and boom sense inputs), as required.
Verify all items in the appropriate hardware mounting kit are present:
HARDWARE KITS
STANDARD HARDWARE KIT (46649-0380) FOR CONSOLE
AND SWITCH MODULE:
(1) Combination mounting plate (46649-0580)
(2) U-bracket (46649-0590)
(3) Two 1/4 - 20 x 1 inch hex bolts
(4) Five 1/4 inch split washers
(5) Two rubber washers (46390-0900)
(6) Two knob screws (20072-0022)
(7) Three 1/4 - 20 x 3/4 inch hex bolts
(8) Retaining clip (46649-0350)
(9) Two #6 self-locking hex nuts
(10) Three #6 plastite screws
OPTIONAL HARDWARE KIT (46649-0390) FOR CONSOLE
ONLY:
(1) Console mounting plate (46649-0370)
(2) U-bracket (46649-0590)
(3) Two 1/4 - 20 x 1 inch hex bolts
(4) Five 1/4 inch split washers
(5) Two rubber washers (46390-0900)
(6) Two knob screws (20072-0022)
(7) Three 1/4 - 20 x 3/4 hex bolts
(8) Retaining clip (46649-0350)
(9) Two #6 self-locking hex nuts