OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
KEYBOARD PROGRAMMING / 31
Metric units. Parameter values will change on all screens immediately
and convert to the equivalent numerical values.
– Select either Y(YES) or N(NO). Y changes units to metric; N retains
the units in English.
– After selecting English or Metric, select units of measure from the
remaining list.
English
choices available are miles, miles-feet, square feet, or
square yards and 1000/ft
2
.
Metric
choices are kilometers, kilometers-meter, square meter and
kg square meter.
This list allows only one selection. Pressing the
Enter key is not necessary to accept the choice.
Figure 21
Setting System Units
SERIAL PORT CONFIGURATION
5. Select F12 to return to the Misc Menu and select Serial Port
Configuration (4). (Refer to Figure 22). This menu allows setting of the
serial port for communicating with other devices. Values must match
the serial data format of the other serial devices. The Esc key accepts
the values instead of the Enter key. The pre-programmed values are
appropriate for use with other DICKEY-john equipment and software.
– Press 1 for the Baud Rate Select screen. Use the Up/Down arrow
keys to change the baud rate. Press Esc key when finished.
– Press 2 for the Data Bit Select screen. Use the Up/Down arrow
keys to change the data bits to be used. Press Esc key when
finished.
– Press 3 for the Parity Select screen. Use the Up/Down arrow keys
to change the data bits to be used. Press Esc key when finished.
– Press 4 for Modem Setup screen (wireless users refer to CP Tools
Software Manual for wireless communication hardware). Channel,
PC address, Truck address and Truck ID are required entries for
wireless transmission. Press Esc key when finished.
SYSTEM UNITS
METRIC
NO
MILES NO
MILES – FEET
NO
SQ. FEET
NO
SQ.
YARD
NO
1,000 SQ. FEET
YES
Select Item 3
from F12 Function Screen
(MISC Screen)
SYSTEM UNITS
METRIC
YES
KILOMETERS YES
KILOMETER-METER NO
SQ. METER
NO
KG SQ. METER
NO
English
Metric
Summary of Contents for Control Point
