EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE
14.7 INSTALLATION OF THE DD15 CYLINDER HEAD
Install the cylinder head as follows:
1. Inspect the head bolt holes in both block and head for the presence of oil, water, dirt, or
damaged threads, clean or re-tap as necessary. Ensure piston domes and the cylinder head
and cylinder block deck surfaces are clean and free of foreign matter.
2. Verify that the cylinder liner protrusion heights are all the same prior to installing the
cylinder head.
3. Install Cylinder Head Guide Studs tool (J-35784).
4. Position a new cylinder head gasket onto engine block.
1. Engine Oil Feed Hole
4. Coolant Return Opening
2. Engine Oil Return Opening
5. Opening for Blow-by Duct to Crankcase Vent
3. Coolant Feed Hole
PERSONAL INJURY
To avoid injury when removing or installing a heavy engine
component, ensure the component is properly supported
and securely attached to an adequate lifting device to
prevent the component from falling.
5. Install four lift hooks onto cylinder head.
All information subject to change without notice.
DDC-SVC-MAN-0081 2010
Copyright © 2010 DETROIT DIESEL CORPORATION
14-19
Summary of Contents for EPA07
Page 1: ......
Page 2: ......
Page 287: ...23 OIL FILTER Section Page 23 1 REPLACEMENT OF THE OIL FILTER 23 3 ...