38.8
INSTALLATION OF THE FRONT ENGINE LIFTER BRACKET WITH FRONT ENGINE POWER
TAKE-OFF
38.8 INSTALLATION OF THE FRONT ENGINE LIFTER BRACKET WITH
FRONT ENGINE POWER TAKE-OFF
For EPA07 engines,
install as follows:
1. Install a new EGR connector tube, if needed, onto EGR cooler and install EGR exhaust
gas crossover tube/lifting eye to cylinder head.
2. Loosely install six bolts to exhaust gas crossover tube/lifting eye.
3. Install bolt attaching the exhaust gas crossover tube/lifting eye to the coolant crossover
tube. Torque to 30 N·m (22 lb·ft).
4. Install bolt attaching the coolant crossover tube to the exhaust gas crossover tube/lifting
eye. Torque to 30 N·m (22 lb·ft).
5. Tighten six exhaust gas crossover tube/lifting eye bolts to cylinder head. Torque to 60
N·m (44 lb·ft).
6. Slide mixer pipe onto hose with soap and water for ease of installation.
7. Install venturi to exhaust gas crossover tube/lifting eye with a new gasket and two bolts;
torque bolts to 30 N·m (22 lb·ft).
8. Slide hose onto venturi using soap and water for ease of installation.
9. Install two clamps onto hose and tighten.
All information subject to change without notice.
38-14
DDC-SVC-MAN-0081 2010
Copyright © 2010 DETROIT DIESEL CORPORATION
Summary of Contents for EPA07
Page 1: ......
Page 2: ......
Page 287: ...23 OIL FILTER Section Page 23 1 REPLACEMENT OF THE OIL FILTER 23 3 ...