Detroit Diesel EPA07, Workshop Manual, Page: 435 / 442

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE
25. With the engine mounted on the overhaul stand, remove all of any remaining
subassemblies and parts from the cylinder block.
[a] Remove the rocker cover. Refer to section 1.2.
[b] Remove the engine lifter brackets. Refer to section 38.2.
[c] Remove the vibration damper. Refer to section 36.1.
[d] Remove the fl ywheel. Refer to section 34.4.
[e] Remove fl ywheel housing. Refer to section 34.2.
[f] Remove idler gears. Refer to section 5.2.
[g] Remove camshaft housing. Refer to section 3.1.
[h] Remove the cylinder head. For DD13, refer to section 14.2. For DD15,
refer to section 14.4.
[i] Remove the oil pan. Refer to section 19.2.
[j] Remove the piston and connecting rod assembly. Refer to section 15.2.
[k] Remove cylinder liners. Refer to section 16.2.
[l] Remove the crankshaft. Refer to section 17.2.
NOTICE:
Before removing main bearing caps, be sure each is stamped
or punch-marked in numerical order, beginning with No. 1 at
the front, to ensure installation in their original position. Mark
all caps on the oil cooler side (left side) of the engine to prevent
reversal at assembly. Failure to mark numerical order may result
in the caps being put back in incorrect order, improper crankshaft
support and severe crankshaft or bearing damage or both.
[m] Remove the crankshaft main bearings.
All information subject to change without notice.
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION
42-11