Detroit Diesel EPA07, Workshop Manual

Page: 264 / 442

19.7 INSTALLATION OF OIL PAN
7. Ensure that the seal has not been disturbed. Torque the eighteen oil pan bolt assemblies to
20 N·m (15 lb·ft) using the proper sequence.
8. Install the oil pan drain plug and torque the plug to 45 N·m (33 lb·ft).
9. Install bolt at harness P-clamp on front center of oil pan.
10. Install dipstick tube fi tting if removed from pan and torque to speci fi cation listed in Table
19-1.
Fitting Thread Size Torque Spec
Fitting to pan M20x1.5 60 N·m (44 lb·ft)
Fitting to pan M22x1.5 70 N·m (51 lb·ft)
Fitting to pan M27x1.5 90 N·m (66 lb·ft)
Fitting to pan M30x1.5 100 N·m (73 lb·ft)
Table 19-1 Torque Specs for Pan Fittings
11. Install dipstick tube on fi tting and tighten clamp. Refer to section 20.3.
12. Install dipstick.
13. Install oil fi lter and cap. Torque to 55 N·m (40 lb·ft).
14. If oil pump was removed, follow section 21.4.
15. Prime the lubrication system. Refer to section 27.1.
16. Re fi ll the oil pan with lubricating oil. (refer to specs for oil quantities).
All information subject to change without notice.
19-10
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION